How To

Initial Use

Insertion

Removal

Maintenance

Initial Use

Step 1
Rinse the Case

Wash your hands thoroughly. Rinse the entire inside of the Y‑Tip Case with multipurpose disinfecting solution (MPDS). Discard the rinse.

Step 1 Rinse the Case

Step 2
Rinse the Y-Tip Applicator

Remove Y-Tip from blister. Rinse the tips. Fill the case basin with MPDS to fully cover the tips. Close the lid and soak.

Step 2 Rinse the Y-Tip Applicator

Step 3
Tweezer Handling

Keep Tweezer in its blister until use. Check for debris before each use. Rinse with MPDS if needed. Store in the Tweezer Case or a clean, dry place.

Step 3 Tweezer Handling

Insertion of Contact Lenses

Step 1

Take the disinfected Y-Tip out of the applicator case. Hold it between thumb and index fingers, tips up.

Step 1

Step 2

Use the Transfer Tweezer to pick up your lens. Check for debris and rinse if needed.

Pick up contact lens with tweezers

Step 3

Place the lens between the Y-Tip arms. Gently pinch to secure it.

Place the contact lens in your Y-Tip Applicator

Step 4

Use one hand to pull down the lower lid and the other to lift the upper lid to secure your eyelids open.

Use the Y-Tip to place the lens onto the eye. Gently open the tips to release the lens onto your eye.

Repeat Steps 2–5 for the other eye.

Place the contact lens onto your eye

Step 5

Empty the used MPDS. Refill the basin with fresh MPDS and submerge the tips. Store the Tweezer in a clean place.

Step 5

Removal of Contact Lenses

Step 1

Take the disinfected Y-Tip out of the applicator case. Hold with tips up.

Remove the disinfected Y-Tip Applicator

Step 2

Hold your eyelids open. Place the Y-Tip in the open position onto the lens and pinch gently to remove from the eye.

Remove the contact lenses from the eyes

Step 3

Follow lens care guidelines or discard if disposable. Repeat for the other eye.

Step 3

Step 4

Empty the used MPDS, refill with fresh MPDS, and submerge the tips for disinfection. Close the lid.

Step 4

Care and Maintenance

Deep Clean (Weekly)

Wash your hands thoroughly. Wet the Y-Tip tips with MPDS and rub each tip for 20 seconds. Rinse for 5 seconds using MPDS. Refill the basin and submerge the tips for disinfection.

When starting a new Y-Tip (replace every 30 days), rinse the case interior with MPDS (Step 1 of Initial Use).

Deep Clean (Weekly)

Replacement Schedule

Replace the Y-Tip every 30 days, and the case and tweezer every 90 days. If damaged, replace immediately. Order replacements at optodex.com.